The HJCD pelletizer systems convert the stream of molten polymer into pellets.
A number of strands emerging from the die head are directed through a cooling bath and cooled there.
Then the cooling water sticking to polymer strands is air-wiped off by a suction and blowing nozzles of an air wiper before strands are led to a pelletizer.
The dried and cooled strands are directed to a strand pelletizer where strands pulled out by two(2) feed rollers and cut into pellets by a rotating cutter.
The discharged pellets are conveyed into a vibrating screen which selects pellets into normal, oversized and powder.
This system requires operator's skill during start-up and operation. All strands formed at the die head flows down the cooling bath through an air wiper into the pelletizer whilst operator in presence.
The Die head, cooling bath, air wiper consisting conventional pelletizing system also belong to our scope of supply.
Compounding industries : ex) ABS, SBS, Polymers on request Master batches, application where changing product/color is frequent Engineering plastics : ex) PET, PBT, PA+GF, Mineral reinforced Virtually any applications for plastic industry
Strand inlet chute designed for safety purpose & strand guide roller Cutting chamber with built-in sound insulation for noise level guarantee ≤85dB Stable strand feeding design by 'partial strand wrapping around lower feed roll' and 'low pressurized free-driven upper feed roller' Bearing housing outside of cutting chamber for protecting product contamination and ensuring easy maintenance Time taken in replacing 'lower feed roller' and 'rotary cutter' : 10 min Anti-fly back plate inside of cutting chamber for protecting pellet accumulation in cutting chamber Drive mount : Beside or Below cutting chamber Mobile frame with maintenance stool Electric panel : integrated or separated with pelletizer, with operator friendly concept In principal, all parts contacting with products and water are made of stainless steel
M/C type
Specifications
HJCD-75
HJCD-200
HJCD-300
HJCD-600
HJCD-800
Capacity (ton/hr)
0.5~1
1~1.5
2~2.5
3~4
4~5.5
Cutting Width (mm)
75
200
300
600
800
Rotor Drives (kW)
2.2
7.5
11
22
30
Strand nos (nominal)
20
50
75
120
150
Draw-in Speed (nominal)
30-90m/min
Pellets Dia 3 X 3 L Capacity will vary depending on the specifications of pellet, no. of strands, specific gravity of product and process speed range Technical data are subject to change in basic condition differences
Compounding industries : ex) ABS, SBS, Polymers on request 
